| BRAND | Warex |
| Product | Type DKZ 110 APS DN 150 |
| Description | Butterfly valve |
| Internal code | IMP4710061 |
| Custom code | 84818085 |
| Technical specification | Butterfly valve, Overall length 56 mm for clamping between flanges according to EN 1092, PN 10 Silumin housing Flap disc made of stainless steel 1.4408 - with increased gap size - Shafts made of stainless steel 1.4057 or higher Shaft sealing with O-rings shaft bearing Sealing sleeve made of gray silicone exchangeable in the housing pneumatically tensionable against the valve disc < APS > The valve has the following special equipment: with mounted shaft extension, steel, Height 150mm for heat dissipation + flat gasket made of Isoplan 750; 2mm thick Execution according to drawing: 1024994Mb further attachments: Pneumatic rotary drive AT 60 DR double-acting required control pressure 6.0 bar el./pneumatic Control for APS flaps Type: DKZ110 / 103 <APS> *** PLC required *** (Attention! Solenoid valves must be equipped with 2 separate controlled by signals from a PLC! ) for opening and closing butterfly valves Series: DKZ 110 / 103 < APS > consisting of: 1 piece mounting plate for Namur valve 1 ball valve MS, 1/4" internal thread with hand lever 1 pressure reducer, make Knocks 0.1-3 bar, type RE01G including manometer (1006270) incl. retaining plate and screw connections Execution according to tax plan no. 0004324 - Ventilation of the sealing sleeve using the on-site vacuum system - Piping of the line from the valve to the sealing collar in stainless steel (screw connections checked for leaks) - including checking the seal for pressure loss Solenoid valve 5/2 way function Norgren 2623077.3036 24 V DC, 1.6 W, IP 65, Namur version - without plug - Solenoid valve 5/2 way function Norgren 2623077.3036 24 V DC, 1.6 W, IP 65, Namur version - without plug - Limit switch box with double sensor P+F NBN3-F25F-E8-V1 3-wire type, PNP normally open, 10-30 V DC installed in Vestamid/PRB round housing Diameter 80 x 50 with V1 device connector M12x1, 4-pole, ---- without angled socket --- |
default.send_request_amp_Group2