| BRAND | Demag |
| Product | ADE60DD Oel: 4,0 LI |
| Description | flat gear |
| Internal code | IMP4866764 |
| Technical specification | Technical description Thanks to their compact design, Demag flat gearboxes are the ideal solution for drives that require limited installation space must. The modern modular system offers a wide range of services. Even high translations can still can be carried out in two stages. This ensures particularly smooth running and good efficiency due to the optimised tooth geometry. Thanks to the special, integrated shaft-hub connection, the transmission is also very good for reverse operation suitable. The variety of output shafts - hollow shaft or solid shaft, with dowel spring or multi-wedge gearing - and the Attachment variants as plug-in gears with torque support, foot or flange design enable optimal use of Cost-effective solution adapted to the application. The transmissions are available as solo clutch transmissions or compact direct drive. Even in the basic version, the flat gearbox offers you an exceptionally wide range of options, Optimally solving drive tasks. Thanks to numerous options, the transmission can be used economically to a wide variety of Tasks can be adjusted. The spectrum ranges from torque supports to special lubricants and special paints. Technical data: ADE60DD-D1.0-76-0 design code Translation 60.60 for mounting on motor 100 Horizontal installation position Ambient temperature -10... +50 °C The ratio i=60.60 is in the product phase-out phase and is exclusively for replacement drives to use. Please choose the corresponding 3-step translation i=62.60. equipment: Clip-on design Solid shaft with evolved left/cover side, extended shaft design Right oil level suction Transmission with vent valve basic gear, without motor, Delivery without oil filling (oil quantity and oil quality can be found in the assembly instructions), with transmission seal, For direct drive Colouring: RAL 5009, azure blue increased corrosion protection: acid protection paint (C3) Construction or mounting surfaces do not maintain the color structure with increased layer thickness. In order to avoid setback and to achieve the required coefficient of friction The layer thickness here is limited to 60-100 μm. After the components have been installed on site, the customer is provided with suitable corrosion protection for unnecessary to carry out construction surfaces, parting lines and any other possible attachments. documentation: Assembly instructions EU documents in accordance with the Machinery Directive |
default.send_request_amp_Group2