| BRAND | Labom |
| Product | CV3110-A1059-F80-H1100-M2-N51-T31-K1085-W4020-W2002 DL3230-HY-A4007-L23.100-W4035-W1020-W1101-W1102 |
| Internal code | ONR4890333 |
| Custom code | 90262020 |
| Technical specification | Spare part for Fab.-No.: 1312688/01/001 CV3110 PRESSURE TRANSMITTER PASCAL CV, for diaphragm seal operation, hygienic acc. to data sheet D4-017/22 A1 pressure sensor: piezoresistive for gauge pressure 059 nominal range: 0...16 bar, overload limit 60 bar measuring range setting: turndown 5:1 accuracy: <= 0.15% of measuring span (linearity, hysteresis and repeatability) F80 measuring range: setting see below lower range value: - 1,000 upper range value: + 9,000 unit: bar H11 output signal: 4..20 mA, rising characteristic (standard) 0 setting damping: 0.0 sec. (standard) 0 setting alarm state: < 3.6 mA (standard) M2 display module: multifunctional display with 5-position digital display and bar graph, pluggable N5 switching module: with 2 floating channels, pluggable, electrically isolated at all sides, switching capacity 30 VDC/0.5A 1 switching module setting: at the factory, see below 1. switch contact: 5,5 bar, breaker, hysteresis: falling 2. switch contact: Without case: hygienic housing design with screw cap material: stainless steel degree of protection: IP 66 T31 electrical connection: circular connector M 12x1 (8 pin) K1085 design standard ‘W4020 ADDITIONAL DESIGN: marking (adhesive label), see below ‘W2002 CALIBRATION PROTOCOL: with 5 measuring points DL DIAPHRAGM SEAL for food / pharmaceutical / biotechnology 3 design with clamp connection see data sheet D5-026 230 process connection: per DIN 32676 model C (Tri-Clamp) for pipes per ASME BPE, DN 1 1/2"/ PN 25 HY hygienic design per EHEDG Doc.8 and ASME BPE SF3: surface roughness (wetted parts) - tumed parts Ra <= 0.76 ym - diaphragm Ra 38 ym - weld seam Ra <= 0.76 ym A400 connection of meas. instrument directly welded 7 material wetted parts: stainless steel mat-no. 1.4435 (316L) L23 system filling: Synthetic oil, free of silicon FD1 acc. to FDA 21 CFR 178.3570 / H1-registered 100 temperature, media: 0...+140 °C ‘W4035 ADDITIONAL DESIGN: wetted parts electropolished W1020 Components marked acc. to material inspection certificate per EN 10204-3 1, wetted parts W1101 TEST REPORT per DIN EN 10204 2.2 W1102 TEST REPORT per DIN EN 10204 2.2 as per customers specification, see below 'W1101 Certificat EN 10204 2.2 to confirm the following points: - Confirmation of FDA conformity of the system filling used - Confirmation of electropolishing - Confirmation of surface roughness <0,8 pm - Conformity to the order |
Press on flag images to see contact information!
